Order Line:  01142 357717


APQM 6.35mm Jack Outreach Plate

£36.00 exl VAT

APQM 6.35mm Jack Microphone Outreach Plate.

In stock

SKU: APQM Categories: ,


APQM 6.35mm Jack Microphone Outreach Plate.


Key Features

  • Accepts balanced or unbalanced electret microphones with 6.35mm (1/4″) jack plugs.
  • Part of C-TEC’s patented ‘Outreach Plate’ audio input extension system (see key features section below for details).
  • Compatible with C-TEC’s entire range of PDA102, 200E, Pro-Range and ML1 induction loop amplifiers.
  • Can be connected to any third-party audio or induction loop amplifier using an APV 24V 250mA power supply.
  • Mounts on a 25mm standard UK single gang back box.


Technical Specification

Power requirements Supply volts: 12-32V regulated d.c.; Supply current: 12-15mA.
Controls Adjust input level.
Input signal level -50dBv (5mV mic)
Gain 55dB.
Level control 0dB to -46dB
Input impedance 500
Phantom volts 8V/0V (link selectable)
Signal to noise ratio Greater than 75dB
THD + noise Less than 0.02%
Product dimensions (mm) W 85 x H 85 x 15 D mm. Mount on a standard 25mm single gang UK back box.
Construction & finish Plastic.
IP Rating IP20.
Weight TBC
Operating conditions/temperature -5ºC to +40ºC. Max relative humidity: 95%.





Additional Information

The Outreach Plate audio input extension system comprises a range of wall, ceiling and desk mountable plates specifically designed to increase the audio input capability of any audio system. Covering the most common variants of audio connectors, they work by mixing the signals from various audio input sources into a single balanced line level input on a compatible amplifier.

Each input plate features a built-in mixer, preamp, input level control and balanced output.

Typically, up to 10 Outreach plates (any mix) can be daisy-chained to one balanced line level connection.  Cable lengths up to 100m are easily achievable using standard two-pair audio cable (i.e. Belden 8723).

Each plate requires four wires; two balanced line (Line/A +, Line/A –), one ground (GND) and one power connection (V+ = 12-32V d.c.).

Most of C-TEC’s PDA Range induction loop amplifiers are fitted with an Outreach connection socket as standard. For audio systems that do not have an Outreach socket, straightforward network connection can be achieved using an ‘APV’ 24V 250mA d.c. regulated power supply and an ‘APXO’ 3 pin XLR balanced line output plate.


There are no reviews yet.

Be the first to review “APQM 6.35mm Jack Outreach Plate”

Your email address will not be published. Required fields are marked *